When a new major versionīecomes available, it will not be supported until it is fully tested. Typically the current version and the previous two versions. Note An圜onnect 3.1.x is end of life March 1, 2016.Īn圜onnect 3.1.x and An圜onnect 4.x for desktopĪn圜onnect 2.4 and later for mobile devicesĪctive support and testing with the latest Secure FirewallĪSA release is limited to three major versions of each operating system and browser, For example:Īn圜onnect was rebranded to Cisco Secure Client.Ĭisco Secure Desktop was deprecated in April 2014.Īn圜onnect 3.1.x is end of life March 1, 2016.Ĭisco Secure Client 5.0 and An圜onnect 4.x for desktop and mobile.Ĭisco Secure Client 5.0 and An圜onnect 4.xĪn圜onnect 4.x for desktop An圜onnect 4.0/4.1 for mobile. Some minimum versions listed below may currently be end of life and no longer available on. Performed only on currently supported products. Cisco Secure Client Release 5 Mobile DevicesĪlthough versions other than those listed below may work, Cisco is not claiming support or full testing, and fixes will be.End-of-Life Announced for An圜onnect 3.x.Cisco Secure Firewall ASA, ASDM, and Cisco Secure.If you use the recommended address mask, some routes assumed by the VPN configuration might be ignored. It’s recommend that rekeying times on the server be set to one hour.ĪSA address mask: Make sure all device address pool masks are either not set, or set to 255.255.255.255. Rekeying of phase 1: Not currently supported. Load balancing: Supported and can be enabled. Standard NAT traversal: Supported and can be enabled (IPsec over TCP isn’t supported). Perfect Forward Secrecy (PFS): For IKE phase 2, if PFS is used, the Diffie-Hellman Group must be the same as was used for IKE phase 1. IKE exchange modes: Aggressive mode for preshared key and hybrid authentication, or Main mode for certificate authentication.Įncryption algorithms: 3DES, AES-128, or AES256.Īuthentication algorithms: HMAC-MD5 or HMAC-SHA1.ĭiffie-Hellman Groups: Group 2 is required for preshared key and hybrid authentication, group 2 with 3DES and AES-128 for certificate authentication, and group 2 or 5 with AES-256. You can specify these settings to define how IPsec is implemented: Authentication credentials and identity asset settings.Legacy interactive profile declarative configuration.Legacy profile declarative configuration.Subscribed Calendars declarative configuration.Google Accounts declarative configuration.Privacy Preferences Policy Control payload settings.Dynamic WEP, WPA Enterprise, and WPA2 Enterprise settings.Kernel Extension Policy payload settings.Extensible Single Sign-on Kerberos payload settings.Extensible Single Sign-on payload settings.Exchange Web Services (EWS) payload settings.Exchange ActiveSync (EAS) payload settings.Conference Room Display payload settings.Certificate Transparency payload settings.Certificate Revocation payload settings. Certificate Preference payload settings.Autonomous Single App Mode payload settings.Active Directory Certificate payload settings.Automated Certificate Management Environment (ACME) payload settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |